PTI_Product_Catalog

Get the fuel warming efficiency you desire and the thermostatic control you need in one factory assembled product that is installed in the fuel tank. FEATURES • Diesel & BioDiesel Compatible HOT FOX WITH SHUT-OFF THERMOSTAT IN-TANK FUEL & FLUID WARMERS

®

®

VERTICAL INSTALLATION For maximum heat transfer, select the appropriate tube length for your reservoir. Step 1 - Measure the tank depth How to select the correct In-Tank Warmer length for your application?

Hot Fox

• Heats fuel as it is drawn from the tank to the engine with the remaining heat dispersed inside the tank. • Shut-Off Thermostat On 78°F (25°C) Off 95°F (35°C)

• 304 Stainless Steel Construction • 1/2" NPT Extension Fitting Included

• Installs in a Standard SAE Fuel Sending Gauge Opening • Fuel Tank Adapter Kit Required for Non SAE Openings (See page 151) TYPE OF HEATING • Warm Coolant

Extension

Extension & Standpipe

The Original Arctic Fox Warmer

Part No.

Tube Length 9" / 229 mm

Tank Depth

Coolant Port

Fuel Port 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT

Step 2 – In tank warmers that have a fuel standpipe, the tube length should be 1” (2.5cm) shorter than the tank depth to use all available fuel in the tank.

SHFT-2512-10-12 SHFT-2512-13-15 SHFT-2512-14-16 SHFT-2512-17-19 SHFT-2512-20-22 SHFT-2512-22-24 SHFT-2512-24-26 SHFT-2512-26-28 SHFT-2512-27-29

10-12" / 254-305 mm

1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT 1/2" NPT

12" / 305 mm 13-15" / 330-381 mm 13" / 330 mm 14-16" / 356-406 mm 16" / 406 mm 17-19" / 432-483 mm 19" / 483 mm 20-22" / 508-559 mm 21" / 533 mm 22-24" / 559-610 mm 23" / 584 mm 24-26" / 610-660 mm 25" / 635 mm 26-28" / 610-711 mm 26" / 660 mm 27-29" / 686-737 mm

HORIZONTAL INSTALLATION To maximize heat transfer, install the In-Tank Warmer 1” (2.5cm) from the bottom of the tank. A thread-in adapter (A 1721) or weld-in adapter (A-2060) must be used to provide a leak proof installation.

CAUTION: THE HOT FOX WITH SHUT-OFF THERMOSTAT REQUIRES IT’S OWN COOLANT LOOP—DO NOT PLUMB IN SERIES WITH ANY OTHER COOLANT DEPENDENT DEVICES WARNING: Tank reinforcement MUST be used to provide additional structural support to the fluid warmer to avoid tank cracking, leading to fluid leakage. See page 151 for tank adapter kits.

1 – 1-1/2" (2.5 – 3.8 cm)

1 – 1-1/2" (2.5 – 3.8 cm)

Hot Fox

Hydra Liner

phillipsandtemro.com

phillipsandtemro.com

132

133

Made with FlippingBook Digital Proposal Maker