2024_PTI_Product_Catalog

DIESEL STARTING FLUID SYSTEMS • Measured/metered shot system limits the amount of starting fluid that can enter an engine—provides for optimum starting with less chance of waste or engine damage

®

• High pressure replacement cylinders meet D.O.T. standards • Available in 12 and 24 volt electrical and

mechanically operated models • Uses standard 1 inch cylinders

• Convenient, one person operation • Economical – about 16# per start

Note: Diesel Starting Fluid Systems are NOT for use with engines equipped with glow plug or flame thrower systems, or engines equipped with intake air heater.

KIT DESCRIPTIONS Application specific part numbers are listed on the following page.

E-Z Stock, E-Z Mount Electrical Kit (12 Volt) Part No. 8203237

One part number covers most class 7 and 8 vehicles. Kit includes: 3 atomizers (8202966, 8202974, 8202982), switch, valve fitting, 48" nylon tube, dash decal, 16 gauge wire, valve and mounting brackets & surface-mount thermostat. Starting fluid cylinder NOT included. E-Z Mount Electrical Kit (12/24 Volt) Replace existing systems, or custom design your own. Kit includes: valve and mounting bracket mounting bracket, switch, valve fitting, dash decal, 48" nylon tubing. Atomizer not included.

Standard Electrical Kit (12/24 Volt) Direct replacement for some factory installed systems. Kit includes: Valve, switch, cylinder clamp, valve fitting, dash decal, 48" nylon tubing. Atomizer not included.

Mechanical Kit A simple, economical way to add ether injection. Kit includes: Valve, cylinder clamp, 84" control cable, valve fitting, dash decal, 48" nylon tubing. Atomizer not included.

Aerosol Starting Fluid Valve (12 Volt) Part No. 5801001 Controlled flow valve designed to replace the continuous flow valve used on most agricultural equipment. Uses standard 7.5 – 8.5 oz. spray can (not included). Leak-proof seal and easy one-hand installation of starting fluid can simplify use. Kit includes ether valve and elbow connection.

phillipsandtemro.com

163