2017 Zerostart Temro Catalog

PLUG CONFIGURATIONS CIRCULATION HEATERS

PLUG CONFIGURATIONS (A)

(B)

(C)

(D)

240 Volt 20 Amp

240 Volt 15 Amp

125 Volt 20 Amp

125 Volt 15 Amp

(A) Furnished with standard 120V male plug. (B) Furnished with standard 240V male plug. (C) Furnished with high-current 120V male plug. 20 Amp electrical service required. (D) Plug not attached. High-current 240V detachable male plug is provided. 20 Amp electrical service required.

Standard Plug

Weatherproof Plug

A Note About Extension Cord Selection and Usage: When using an extension cord with one or more heating devices, it is important that the TOTAL current draw of all devices not exceed the capacity of the extension cord or the AC circuit. Use only 3-wire GROUNDED extension cords. Ground Fault Interrupter (GFI) service is also recommended. See page 4 for more information on proper cord length and gauge. All circulation heaters on pages 87-90 are equipped with different male plugs depending on the wattage and voltage requirements of the heater. This diagram shows the plug configuration for the three wattage/voltage combinations that are used. Vehicles with heater hose connected to radiator cannot use circulation type heaters. ACCESSORIES The small size of some engine compartments, especially vehicles with transverse engines, may make circulation heater installation difficult even though it may be listed as a heating option. The following accessories are available for use with circulation heaters:

Part No. 3300090 5/8" (15.8MM) x 3/4" (19MM) Plastic "Y" fitting

Part No. 3300085 5/8" (15.8MM) x 3/4" (19MM) Metal "T" fitting

Part No. 3300086 1/4" NPT (6MM) "A" Adapter to 5/8" (15.8MM) hose

Heating & Accessory Products

Beaded Y (Steel)

Beaded T ( Steel)

Part No.

DIM A

DIM B

DIM C

Part No. A-2321 A-2323 A-3600 A-2322

DIM A

DIM B

DIM C

A-457 A-459

5/8" 3/4"

5/8" 3/4"

5/8" 3/4"

5/8" 5/8" 3/4" 3/4"

5/8" 7/8" 3/4" 7/8"

5/8" 7/8" 3/4" 7/8"

1-800-328-6108 or 952-941-9700 • phillipsandtemro.com

91